Computer hardware refer to all physical parts in PC, which contains a lot of stuff. Once the hardware damaged, the computer could not be used either. Here are some tips for you to maintain the computer hardware.
1. Keep the power cord and red edge line of data lines face to face while connecting the IDE device. Then you will never burn out hardware for anti-plug.
2. Check the connection interface if the interface can’t plugged in while installing the hardware device, as wrong connection can’t plug in interface.
3. Cut off power supply and touch the wall or plumb with your hand to eliminate static electricity before opening the computer case for hardware maintenance.
4. Black screen could be arouse by hardware conflict. You’d better consider of changing the location of card slot if you changed video card or memory card and the computer still can’t work normally.
5. You should reset the monitor refresh rate after re-installing or re-plugging the video driver, or the monitor refresh rate could be set to “optimization” automatically.
6. Use tools like pliers for assistance while installing the CUP fan, then you can control the force and direction with ease.
7. You can change the CMOS jumper of the mother board while encountering with the black screen caused by overclock, to get BIOS return to its factory default condition.
8. You should fully avoid harm caused by metal burr on the PCB board and notice the direction of handholds while installing the hardware.
9. Don’t plug the USB disk after standing up, it will lead to physical deformation and hurt the USB port easily.
10. To oxide layer trouble on the video cord or memory card caused by dust, you should clean it with rubber or cotton coated with liquor, and it could fix the situation of black screen.
11. Never reboot while the hard drive lights on the mother board is glowing, or it will arouse bad track of hard ware or error of partition table easily.
12. When you install hardware drive like optical drive, hardware, floppy drive or CD burners, you should cut corners, or it will cause bad influence on the hardware since vibration.
13. You should choose the memory socket next to CPU socket, while there is only one memory installed.
14. Never use liquor to clean the optical drive or monitor screen, using lens paper or velvet.
15. The optical drive could be forced to get out of the computer by poking the hole on optical drive board.
16. Put the monitor upside down while installing its base, not only more convenient for you to operate but also get more stability.
17. Don’t put the mobile phone next to the monitor or stereo. The incoming message or call will interfere them with wrinkle or noise.
No comments:
Post a Comment